1 / 5
Mould for carbon forged recumbent seat bracket (tested: mod to come)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Split-able mould to carbon forged inferior bracket of my recumbent seat. Velomotion Scopa. Tested. Mod to come.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 424
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This is the split-able mold to produce the lower bracket of my high racer recumbent bike, which is a velomotion scopa.
I printed all parts of the mold. (PETG, 0.1mm, some hours)
Following steps are: clean a bit more artefact, wax steps between layers and all surfaces which will be in contact with the epoxy.
To maintain parts of the mold I/you will need:
- 3 threaded rods (Ex: M6*95, imperial shoul work too if < 7.5mm)
- 6 bolts and washers matching above rods
- 6 piece of wood to not damage printed parts
- 3 clamps, with +/- 175mm capable
- wax to assure demolding and smooth surfaces
- epoxy and carbon (+/- 36ml or cm3: I let you do the math for imperial and do the math according to ratio resin/fiber)
I tested it.
As I hurried a bit I didn't fill up properly the mold.
Mods are to come, here are the idea after my first attempt:
- Only one clamp
- More space between walls to pass fibers
- More angle to demold
- Ejector wells