MOSFET Mount for T-Nut Aluminum Extruded Frames
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple MOSFET corner frame mount for aluminum extrusions. I made this for my Anet A8 Plus, but it will work fine on…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 133
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple MOSFET corner frame mount for aluminum extrusions. I made this for my Anet A8 Plus, but it will work fine on just about any 20x20 / 40x20 / 40x40 frame. It can be mounted either vertically or horizontally, ideally in a corner to connect to a joint in 2 directions.
UPDATE 06262021: I added a version 2 of this model to support changes I made to my Anet A8 Plus. I needed for the MOSFET to the top of the base frame so I moved the mounting screws to a 90 degree offset, only keeping 2 of the three mounting screw holes. I also thickened the base from 2 to 3mm. Additionally, I raised the standoffs and opened the backing area to better support untrimmed through components. I'll add photos of the new mount once I've got it printed and installed.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
100%
Filament: Jinos 3D PLA Indigo
Notes:
The push pins are optional, the board can be screwed to the mount. Use of the push pins may require running a 7/64" drill through the holes.
Category: 3D Printer Accessories