Edge Header Programmer Clip Via Probes (e.g. OpenLog Clone) (Customisable)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Edge Header Programmer Clip Via Probes (e.g.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 356
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Edge Header Programmer Clip Via Probes (e.g. OpenLog Clone)
Author: Brian Khuu 2019
This is originally designed for connecting to OpenLog Clones
I used P100-E2 probes for this
Note: The purple openlog clone Programmer Port essentally has [GND, RST, SCK, M0, MI, Vin]
FYI if programming openlog connect above to
AVR ISP
[MISO(1)][VTG(2)] [SCK(3)][MOSI(4)] [/RES(5)][GND(6)] [MOSI(1)][VTG(2)] [NC(3)][GND(4)] [/RES(5)][GND(6)] [SCK(7)][GND(8)] [MISO(9)][GND(10)] Note: I've also included an experiment, where I included a side grip version. Haven't tested it in practice besides a few test prints, but you can let me know if it works. The nice thing about the experimental version, is it should be easier to use and also adapt to other board types
Print instructions
Category: Electronics Summary
Edge Header Programmer Clip Via Probes (e.g. OpenLog Clone)
Author: Brian Khuu 2019
This is originally designed for connecting to OpenLog Clones
I used P100-E2 probes for this
Note: The purple openlog clone Programmer Port essentally has [GND, RST, SCK, M0, MI, Vin]
FYI if programming openlog connect above to
AVR ISP
[MISO(1)][VTG(2)] [SCK(3)][MOSI(4)] [/RES(5)][GND(6)] [MOSI(1)][VTG(2)] [NC(3)][GND(4)] [/RES(5)][GND(6)] [SCK(7)][GND(8)] [MISO(9)][GND(10)] Note: I've also included an experiment, where I included a side grip version. Haven't tested it in practice besides a few test prints, but you can let me know if it works. The nice thing about the experimental version, is it should be easier to use and also adapt to other board types