Kryptonite lock mount V1 [Check V3 instead!]
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
This mount is very specific to my seatpost but may be adapted or at least give ideas to design your own. For reference, this is the type of seatpost I am using here:
Printed with ABS+, but I will probably reprint in ASA or PCTG next for better layer adhesion. High wall count recommended.
For the central hole I reuse the original long bolt that comes with the original mount. Then for each side M4 bolts that are about 16mm long minimum.
If any questions, let me know.
The model can still be improved for sure, but it has been installed on my bike for the last two months and it is still holding fine without issue.
If anybody has ideas to improve it (to make it lighter and stronger), please let me know!!
- Update August 10th 2023 - Upload of version 1.1 with minor improvements.
- Update September 12th 2023 - Version 1.2 with stronger backplate.