2-Piece 16-magnet magsafe car phone-mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of @sethmoser_412442 Added threads & 16-magnet ring with a sunken face to fit standard mag rings
- Ocena
- 0 / 5
- Polubienia
- 44
- Pobrania
- 179
- Wydruki
- 1
- Wyświetlenia
- 2630
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Public Domain
NOTE: you'll need the nut and spacer rings from the OG model
--------------
The magsafe phone holder I bought included a vent holder-mount and a dash-mount, but only one magnetic attachment, so I made a second one for my second car by remixing sethmosers work.
I added threads to the original mount and a threaded 16-magnet ring (10mmx2.5mm disks) that you don't have to stop/park your printer to add the magnets mid-print or trust them to be press-fit only.
I included a number of modifiers to the files to apply ironing and area-specific infill, as well a a negative volume ring to expose the magnets in the ring and slightly inset the position where the ring will sit. This ensures solid contact and is an added feature that helps prevent the phone from sliding when using 3rd-party/aftermarket rings on the back of your phone (42mm id/ 57mm od.)
NOTE: If you print only the ring without the modifiers, you will need to pause the print to add magnets at some point.
You could use fewer magnets than 16, just keep them evenly spaced and it's should work fine.