Wind-Proof Playing Card Holder for Coyote
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wind-proof card holder designed to hold a single card from the board game "コヨーテ" (Coyote).
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 197
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Printed at 0.3 mm layer height but you may use a smaller number if you want more clarity at the top where it is very slightly curved.
Infill that I used is 10% Gyroid but I think even 5% should works fine.
This model is designed to be wind-proof in one-direction only but it will still catches the card on the other direction so that it is unlikely to fall out.
Additional hardware (Optional):
1) 2x M5 16mm screws and nuts
2) Washers (and super glue)
If you want to make the base heavier, you may add 2 M5 screws and nuts to the side by pressing them into the hole on the side. If you need it to be heavier, you may glue on washers to the bottom.