Vise end for Fuller Vise Clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Vise end for a FULLER Innovak Speed Clamp 2.5X6-in
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 52
- Wydruki
- 1
- Wyświetlenia
- 456
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
** Update January 13:
I reprinted this in ABS-GF in an enclosed printer. Results were better than expected. Very stiff and very strong. Please see updated photos of the black coloured version.
** end update
I broke the end of my Fuller 2.5x6-in speed clamp with my Herculean strength… I thought, about just tossing the clamp the then it occured to me that this would present a nice challenge for a 3D design as it would not be an easy design.
Trying to figure out forces, shear strength (at layer lines), material strengths… after 5 successively better attempts to make this clamp end, I can say this one is better than the one that originally came from the store.
you will need two M5x25mm bolts and a couple of nuts. If you want to use locking M5 nuts, you will likely need to lengthen the screws.
I was able to reuse the padding on the clamp and one of the nuts, but I had to source the bolts and nuts (from my spares drawer), you may want to use washers as well.
The pictured item was printed in ABS filament.
5 walls, 5 top and bottom layers with 55% infill (Magic 5 settings :)
I may also give a tuff PLA or CF filled filament a try in future.
If you make this, and if it is not too much trouble, please leave me some feedback, details and a picture of your make
Cheers,
Dan