NR200 PSU Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this cover to tie everything together in my build. And it hides the wires around the PSU. The RGB strips are…
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 647
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this cover to tie everything together in my build. And it hides the wires around the PSU.
The RGB strips are Phanteks Neon strips and they must be cut to length.
The 55cm one (M5) should reach all the way around but I suggest you get more than you need just in case you make a mistake.
Peel the rubber caps of the ends to reveal the LED strip inside. Can be soldered.
PRINT IN HIGH TEMP PLASTIC, such as PETG. PLA will warp over time inside the PC.
Can be printed in both orientations, use supports either way.
You won't be able to fit the connector through the wire hole, so you need to either remove the pins from the connector so you can fish the wire through, or crimp on a new connector like I did.
The cover is made to be a press fit over the stock PSU cover, but you might need to sand it a little inside, or if it's too loose, you can make up the difference with short strips of something like painters tape.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
0.1000
Infill:
20
Filament: 3DE Premium PETG
Category: Computer