Snapmaker 2.0 A350 Multispoolholder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Multispoolholder for Snapmaker 2.0 A350 Enclosure / Multispulenhalterung für Snapmaker 2.0 A350 Enclosure
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 79
- Wydruki
- 0
- Wyświetlenia
- 785
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
you need:
1x steel rod D10mm or a threaded rod M10 600mm
1x drain pipe D 50x1.8 550mm
4x cylinder head screws M4x16
print:
1x Multispulenhalterung vorne (front)
1x Multispulenhalterung hinten (back)
2x Rohrstoppel für Rohr D50x1.8
print the parts strong enough to carry the weight of several full spools of D200mm.
depending on the printer calibration, it may be necessary to scale the printed parts minimally.
mount the two brackets in the enclosure back at the rear and front at the side next to the door in the existing M4 holes. (4x M4x16 screws)
Note that the two M4x20 Screws (door attachment) must be shortened to M4x12 (see photos) beforehand, otherwise the screws would cross.
put the parts together and insert.
note that the enclosure control cable must be routed up high so that it does not cross the spools.
also note that when the holder is fully equipped, the print height (Z) is limited to approx. 280mm in the rear area of the printsheet. (Collision)