Peristaltic Pump Simple
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fully 3d-printed high-pressure waterpump powered by a common TT Motor. No bearings!
- Ocena
- 4 / 5
- Polubienia
- 72
- Pobrania
- 519
- Wydruki
- 2
- Wyświetlenia
- 4874
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
3d print a simple waterpump! This is a peristaltic waterpump with high pressure and low waterflow. I used it in a small automatic greenhouse where it connected to a spray nozzle.
Hardware required:
- Yellow TT-motor (ideally low rpm and high torque)
- M3-Screws & Nuts
- Washer (not necessary)
- Silicone-tubing (5mm outside diameter)
Tips when building:
Apply a light coat of grease on the pins where the rollers are mounted and on the roller-support screw. I can recommend using some metal-tubing to prevent the silicone tubing from moving. The rotor is a tight press-fit on the tt-motor shaft. Print 3 rollers.
Supports:
Supports are needed for “Housing”, “Housing 2” and “Rotor”