Otto Mecanum: 48mm mecanum wheel servo adaptor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Servo horn adaptor for pre made mecanum wheels
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 119
- Wydruki
- 0
- Wyświetlenia
- 1495
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
The print in place mecanum wheels were ok, but suffered from the use of PLA for the rollers, which really limited the surfaces that they functioned properly on.
I did consider a new self assembly wheel with TPU rollers but discovered that ready built 48mm mecanum wheels were available on Aliexpress.
e.g. https://www.aliexpress.com/item/1005005143230636.html

these are supplied with an adaptor for tt motors. The new 3d printed adaptor replaces the tt adaptor and is used to mount a servo horn.
Fit the horn to the adaptor with a couple of self tapping screws, then fit the adaptor to the servo. Finally push the wheel on to the adaptor.
Peformace on hard floor surfaces is a definite improvement.