Stronger Driver for wind-up bathtub boat v5
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Improved the Driver so that it is stronger (especially useful when printing using 0.6mm nozzle)
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 125
- Wydruki
- 1
- Wyświetlenia
- 443
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution
Mike's wind-up bathtub boat is an amazing model that was very well designed. However I ran into an issue with the driver due to printing using an 0.6mm nozzle. It seems that with these printer settings the driver arms are only getting a single line of filament which breaks after 2-3 uses. This improved version makes the arms a little bit thicker to prevent that from happening as often and might also improve its durability when using an 0.4mm nozzle, but has not been tested.
Recommended to print with 100% infill for the best results.