1 / 5
Optical Illusion wind wheel
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Based on previously posted model I have created an improved model with a more rigid bearing construction.
- Ocena
- 5 / 5
- Polubienia
- 74
- Pobrania
- 363
- Wydruki
- 2
- Wyświetlenia
- 2171
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (7)Wydruki i komentarze (Wydruki: 2) (Komentarze: 3)Remiksy (1)Kolekcje (113)Powiązane
I liked the model as posted by @3DMK which was based on the model of Dalpek. But after printing I found that I do not like the bearing construction between the two big rotors. It was to fragile to my opinion. And I was not able to print the big rotors on my ender3. So I have scaled the rotor by approx. 90% and created my own bearing construction.
Most has a quite rigid fit but a bit of glue is recommended. Mounting instructions:
- First mount/glue the axle through the rotor.
- Fit the bearing within the bearing housing, should be a thight fit
- Slide the axle through the bearing assemly
- Slide/Glue the axle closing ring over the axle to fix the bearing position on the axle
- Slide the complete assembly into the housing.
Repeat the same procedure for the other side.
Parts required:
- Rotor left side
- Rotor right side
- Housing (pay attention to orientation, side with internal support layer should be down. Support only required underneath the extension) (On request I have also uploaded a version without internal support layer)
- 2 x bearing housing
- 2 x axle
- 2 x axle closing ring