Exacto Knife Holder

Finally got around to making a little case for the exacto knife kit set I bought from the dollar store. 

This is my 2nd 3D model I've designed and printed and my first actually functional model so it is a bit scuffed and lopsided here and there but it does the job fine enough.

Despite the little grabby holes I included on the side of the knife cavity to grab it, it's still quite difficult to grab. I just use one of the blades or push from the short end. Also when shut, if you shake it around the blades can escape their little cell but they usually fall back into place if you keep shaking it. 

Overall even though some improvements could be made it is way better than the “case” it came in (basically just part of the packaging) and I am very happy with it, I hope you will be too, be careful with knives and happy printing!!