Massive trackpad holder for Cirque Glidepoint 40mm/curved
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two-part crkbd trackpad holder. Requires three M2 inserts with ~2,5mm size, three short M2 screws, and two M2 screws.
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 132
- Wydruki
- 1
- Wyświetlenia
- 1911
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
There are some corne/crkbd trackpad holders for the 40mm curved trackpad out there (mainly https://github.com/keyboard-magpie/minimal-fpc-i2c-pcb/tree/main/holders) but they aren't really suitable for transportation and feel kinda flimsy. So I made my own massive holder.
If you decide to use this you will need:
- 3 M2 heat inserts with roughly 2.5mm insert size (a bit more or less won't hurt)
- 3 short M2 screws to secure the bottom to the top
- 2 long M2 screws to secure the bottom and the top to the standoffs of your board
Please note if you are using 1.25U keycaps on the outer thumb you might have to shave off a tiny amount of the model depending on the keycap profile you are using. I tested it with DES profile 1.25U and there is just enough space so that keycap and holder don't touch but your experience might be difference. So please check the spacing with the bottom part before you place any heat inserts.