Generic Beitian BN-880 mount to zip-tie it on top of uav
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
About I had a look around, and I didn't really find a solution that i liked much, so I designed my own. there is two…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 201
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
About
I had a look around, and I didn't really find a solution that i liked much, so I designed my own.
there is two channels for small zip-ties in the bottom, and its angled about 20 degrees to the back, so a forward flying drone should have it face upward.
I've test printed it in PET-G and final-printed it in TPU, both variants held my BN-880 just fine (i had to cut it out of the PET-G one, so i could put it in the TPU one.
If this is useful to you, please leave a make-picture :)
Printing it
I've been printing it on the side with tree supports. TPU is recommended.
Category: R/C Vehicles
