Simple Monitor Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Save your neck and back with a one piece monitor stand
- Ocena
- 5 / 5
- Polubienia
- 28
- Pobrania
- 262
- Wydruki
- 1
- Wyświetlenia
- 1026
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
When I started my remote work job they sent me 3 monitors with no way to elevate them and I spent a whole year killing my neck and back with them being way too low. Every time I got the desire to remedy the situation I was dissuaded by being cheap and not wanting to spend $100+ on monitor stands. Instead I did the next rational thing, I built a big Voron and designed this, which almost uses a whole roll of filament. Worth it.
Print Settings
Material: Most things should work
Walls: 5+
Infill: 50
Orientation: On the back (refer to image)
I printed mine in both PETG and PLA and both are good enough. Definitely give it like 6 walls and a good amount of infill. To eliminate the need for supports I printed mine “on it's back”. As long as you have good layer adhesion it should work.
Materials
6x 10mm rubber feet (optional)
I designed in provisions for 6 10mm rubber feet to make sure they don't slide around, but with enough weight and desk pad mine have been sitting still.