Drybox conversion for Rubbermaid FG7M7400CHILI tub
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a set of parts to turn a Rubbermaid FG7M7400CHILI 21-Cup Food Container into a drybox to fit a normal 20-21 cm…
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 1135
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a set of parts to turn a Rubbermaid FG7M7400CHILI 21-Cup Food Container into a drybox to fit a normal 20-21 cm diameter spool, up to 7.5 cm wide.
I made it to store my spool of Atomic Carbon Fibre Nuclear Nylon separately from the rest of my filament.
The fitting pieces are designed with the intent that you'll use a PC4-M6 pneumatic fitting, into which you'll push-in a short length of 2 mm ID/4 mm OD PTFE tubing to act as a guide tube (to help block moisture from reaching the filament that would otherwise be exposed).
The inner piece acts as a nut, and the outer piece acts as a gasket, which when used with the inner piece's cap should create a sufficiently-airtight seal to keep humidity out when not printing.
You'll of course need to print two each of the base and roller, two each of the regular desiccant box and its snap-in lid, and one each of everything else.
The only modification you'll need to do to the container itself is to poke a small hole for the PC4-M6 fitting. Inside, I taped the moisture indicator card that came with the filament.
Vitamins
4, 688ZZ bearings
4, M3 x 20 mm screws
4, M3 nuts
Print instructions
Print everything in whatever filament you favor, except for the fitting outer piece and the cap for the inner piece.
Do those in TPU. The "tail" of the cap fits through the small offset hole in the inner piece, like a clothing tag, before screwing the inner piece onto the PC4-M6 fitting.