Insect net window connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a small connector to hang a very simple diy insect net to a sash and case window
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 307
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Share Alike
I wanted a simple solution to prevent flies and mosquitoes from entering when I open the windows.
- I have some aluminium profiles used for LEDs like this ones
- I have some leftover lill IKEA sheer net curtains
- I have a window with rings (apparently they're called sash eyes)
- I have a 3d printer
So after making sure the profiles and the curtain have the correct length for the window, just roll a bit of net around the profile, install the connector, another profile at the bottom of the window to hold the net in place and voila, an insect net.
I printed with draft quality (0.24mm) at high speed without supports or brims using ABS (so that it can be a little flexible), and used a wall count of 4 (but I don't think it was necessary).
The onshape doc with parameters for different sizes and thickness can be found here