1 / 7
Battery Dispenser (AA/AAA)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed Model to dispense AA/AAA batteries with minimal material usage and improve fit/tightness on the batteries
- Ocena
- 4 / 5
- Polubienia
- 62
- Pobrania
- 842
- Wydruki
- 13
- Wyświetlenia
- 2953
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 13) (Komentarze: 15)Remiksy (0)Kolekcje (73)Powiązane
Really liked the design of the model I've remixed but I don't tend to hang on to the discard batteries once I've used them up.
As part of this remix the changes were:
- Removed discharged bin
- Fixed AA/AAA Letters and centered
- Fixed Sizing of the bins to be even (Front to Back)
- Fixed Sizing of the AA bin as it was ~55mm in model and AA battery is only 50.5mm so tightened that up a bit
- Removed the extra material spend at the bottom (previously was solid block) and left the ramps as only 2mm thick. I had no trouble printing without supports for the ramps
- Rounded over/filleted the feed tray edges/tops/sides/corners
- Re-did some of the corners/round-overs of the feed tray
Capacity wise, I don't have enough batteries on hand to fill it. I put in all the batteries I had around the house and barely filled the bottom. Will leave it to someone in the comments.
Feed is very smooth and the fit is good without contact on both ends. I'm happy with it and it cleans up my battery cabinet!