Daytona Super Duty 3 Ton Jack Tray
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A tray for the Daytona Super Duty 3 Ton Jack
- Ocena
- 5 / 5
- Polubienia
- 50
- Pobrania
- 377
- Wydruki
- 1
- Wyświetlenia
- 3955
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Background
This is a tray to use instead of the cover on the Harbor Freight Daytona Super Duty 3 Ton service jack. I find myself wanting to put lugs nuts somewhere when pulling off the wheel so this is a good place to store them or other hardware/components when jacking up a vehicle.
This may fit other Daytona service jacks but was specifically designed for the Super Duty 3 Ton jack.
The distance between frames/tray width is 166mm wide. The distance between the CLs of the holes is 55mm and is sized for a M5 heat-set insert from McMaster.
https://www.mcmaster.com/94180A361/
Printing Instructions
- The print is designed to be printed with the seam to the back. You may need to rotate the model 180 degrees so the front wall (below the text) is oriented to the back so the seam gets placed at the sharp in the wall.