Opel Sign on asymmetric stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made a new stand for the Opel-sign, made by Giack_95's (https://www.printables.com/de/model/280453-opel-logo).
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 176
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remixed version of Giack_95's design (https://www.printables.com/de/model/280453-opel-logo).
I have resized the model to 200% (160 mm outer diameter, 16 mm width) and redesigned the logo's stand to match the curved design of the logo.
Both the 160 mm version and the 80 mm version of both the stand and the logo itself are available for download.
The lowest point of the stand's groove, where the sign is held, is designed at 8.067 mm width in Fusion360. If your printer has higher tolerances, consider rescaling the stand by +- 1% in the slicer to achieve a better fit.
I printed the black model seen in the picture using the test roll of Qidi rapido PLA that came with my printer, using Qidi slicer's standard profile.
The total dimensions of the stand plus sign are approximately 112.5 mm x 80 mm x 21.5 mm (225 mm x 160 mm x 43 mm for the 200% version).