18mm Drone Skid for Kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix for https://www.thingiverse.com/thing:4002006 Needed a skid that was taller to clear some screws that…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 158
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is a remix for https://www.thingiverse.com/thing:4002006
Needed a skid that was taller to clear some screws that were sticking out of the bottom of a drone kit. The skid is 18mm tall and uses M3 x 12mm screws that go into your motors. I believe M3 x 14mm will also work.
It will fit this drone kit frame. I'm not sure what standard spacing those hole sizes are on this kit, but it fits this:
Print Settings
Printer Brand:
TEVO
Printer:
Rafts:
No
Supports:
No
Resolution:
.25mm
Infill:
20%
Filament: Matterhackers PETG Orange
Notes:
I printed with 4 walls, about 4 bottom and 12 top layers. I wanted the top area (the area that ends up touching the ground to be pretty solid.
Category: R/C Vehicles