Eibos Cyclopes Filament Dryer handle - single finger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A single finger lift handle for the Eibos Cyclopes Filament Dryer.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 265
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
The Eibos Cyclopes Filament Dryer does not have a handle and it bugged me a lot that they didn't design something like this.
*The holes are slightly smaller for drilling/sizing on your own**
- You will need a small bit or an M4 tap bit to make the hole a little wider. Here is a link for a great metric tap set…
https://www.amazon.com/gp/product/B0861QXJ6Z
-The holes are 10mm deep in the handle.
- Uses (2) M4 x 12mm button cap screws.
Eibos Cyclopes Filament Dryer....
https://www.amazon.com/Official%E3%80%913D-Filament-Adjustable-Temperature-Compatible/dp/B0BFQXHRV5
Print Settings
Printer Brand:
TEVO
Printer:
Rafts:
No
Supports:
No
Resolution:
.25mm
Infill:
30%-100%
Filament: Matterhackers PETG Orange
Notes:
I did something like 30%, 4 top and bottom layers, 3-4 walls.
You can do 100% if you want. I don't think it matters that much.
Post-Printing
Tap set does help. You could also use a drill bit sized for just under M4, then drive the M4 into the handle from inside the lid.
Category: 3D Printer Accessories