Pull Cord Management for Fiskars PowerLever Pruner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is for the Fiskars 14 ft PowerLever Tree Pruner (1-1/8 in. Cut Capacity).
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 38
- Wydruki
- 1
- Wyświetlenia
- 326
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This is for the Fiskars 14 ft PowerLever Tree Pruner (1-1/8 in. cut capacity). It likely works with the shorter and longer models as well.
It is a great tool, but there is not a built-in way to manage the pull rope for the pruner to keep it from getting tangled up during use or storage. This solves that problem! Note that you do need to unloop it before extending the length.
Print 2 pieces.
Remove the rubber plug at the bottom of the pruner.
Install the top one with the leg facing up and slide most of the way up (mine is about 24-in below the top of the clamp lever).
Install the second one with the leg facing down and slide a little ways up (mine is about 12-in above the plug at the bottom).
Material for image shown is Hatchbox ABS (orange). Layer height is 0.35 mm and fill is 50%. using default Hatchbox ABS settings from PrusaSlicer.
The printed parts fit very snugly as drawn in ABS. Not sure how the fit would be in something that prints truer to size, like ASA.