Kronos Stack Base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stack Base 3d print which lets you mount the ESC without using gummies. Protects against shorts on the frame inserts.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 187
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Public Domain
Stack Base 3d print which lets you mount the ESC without using gummies. Protects against shorts on the frame inserts.
Prints without supports good enough for the use case, which isn't visible on an assembled drone. Not tight enough to hold the screws if you're trying to use locking nuts on your build, so you'd have to disassemble the build enough to hold the screws with a tool if that's your desire.
The low version should be used with gummies on the esc, and it'll be about as low as is possible. I'm using it with a diatone F65 and I can get the FC and LEDs on stack screws without compressing the stack at all. Also leaves enough room above for the hdzero vtx top mounted on a kronos with 20mm standoffs.
She tight but she fit.