Bambu Lab Filament Cutter 45°

This is a Remix “Bambu Lab Filament Cutter 45” for an project "Filament Cutter 45" Design by @Pomi

ATTENTION - WEAR GLOVES TO PROTECT AGAINST CUTS WHEN INSTALLING THE BLADE. USE PLIERS TO ASSEMBLE THE BLADE !!!

Hello Everyone

I didn't realize such a great tool for cutting filament existed until I discovered it. I can't imagine 3D printing without Filament Cutter now. I wanted to add the Bambu Lab Logo to the original design but the walls were so thin that they became transparent after printing. That's why I decided to design the Filament Cutter from scratch, based on the original design. Relative to the original, all walls are 0.4mm thicker. I also changed the center to make the whole mechanism work even smoother than it was in the original design. I also changed the blade socket to make it more snug and not fall out like the original.

When you complete the project, please share a photo and a comment. Thank you and have a nice day.

Versions Available : 

Bambu Lab Filament Cutter Body :

• No Logo - Protruding Logo - Color logo

Bambu Lab Filament Cutter Button : 

• No Logo - Color logo

What Should I Print? :

• Filament Cutter Body - 1pc
• Filament Cutter Button - 1pc
   

What Should I Buy? :

• Snap-Off Blades 18mm - 1pc (One Blade Segment) - I recommend the Olfa ExcelBlack Blade - Proper assembly of the blade is shown in the photo gallery
• Screws M3 25mm - Cylindrical Head - 2pcs - https://a.aliexpress.com/_EIQRvnr
• Pen Spring (Length 20mm - Diameter 4mm) - 2 pcs - Most pens have such springs. If it is longer, just shorten it to 20mm - https://a.aliexpress.com/_ExdgyBD
  
  IMPORTANT - READ:
  Please note that printing a Filament Cutter with a colorful logo takes a long time. Consider choosing a version without a logo or a version with a logo but without color. 
   
   

How to print ? :

• Material : Any (I tested on PLA, PLA Plus and PLA-CF)
• Layer Height : 0.2mm
• Wall Loops : 3
• Bottom Layers : 4
• Top Layers : 4
• Infill : 40% (I print with 100% infill because I want it to be heavy and massive)
• Seam Position : Back
• Support : No
• Brim : No
• Brim Auto : No (Be sure to disable Brim Auto. When printing in color Filament Cutter Button with Brim Auto on, it may cause a problem on the first layer)