1 / 9
Cell Phone Holder for Vehicle with Coin/Ashtray Holder — zdjęcie 1
1 / 9

Cell Phone Holder for Vehicle with Coin/Ashtray Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This was printed for my motorhome, so the cell phone can be in view whenever required and plugged in for Carplay.

Ocena
0 / 5
Polubienia
7
Pobrania
93
Wydruki
0
Wyświetlenia
1266
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I have a motorhome with a large center console with a removable coin/ashtray accessory(Ford E450 chassis).  I also have a screen that allows for carplay, so I wanted a place where I could hold the phone, have it plugged in for charging while driving, and see the phone if I should need to see anything.  This was designed to fit in the recess left when you pull out the coin/ashtray accessory.  I didn't know what angle would be best, so it is designed in multiple parts so that the main cell phone holder part slides onto a post, so that it can be rotated to any direction.  There is a screw in that part that can be tightened against the post to stop it from swiveling once the best angle is set.  The part that inserts into the cup holder was designed specifically for my motorhomes cup holder, so I really don't know if it will fit in other cup holders or not, as I haven't tried it yet.  

The part that fits into the cup holder recess can be printed upright, no supports should be required.

The post part is printed with large base down, no supports required, and is then screwed down on to the cup.  The main part that connects the phone attachment plate to the post is printed upside down on the flat part, no supports are required.

This was my second version of the cellphone holder, in the first version I had made the phone attachment all as part of the main piece. I realized if my phone ever changes, the entire part would have to be reprinted if I had to change any sizes.  This new design I made an attachment plate that bolts on, so that if required at some point with a different phone size, just that part would be redesigned, then it can be bolted on to the main connector part using the same four bolts.

The phone attachment plate is printed with flat part down.  The reason I made the tabs as separate is so that the attachment plate wouldn't need supports when printing.  After the tabs are printed, I just glued them down.  I put an alignment ridge on the tabs so that they are easy to line up for gluing.

I used Prusament ASA as I thought it might stand up to the heat better if the cab is in the sun.

Tagi