Uniphoxx Slingshot band clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you are getting a lot of frame hits because you suck at tying bands to the forks like me, you would probably want a…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 479
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
If you are getting a lot of frame hits because you suck at tying bands to the forks like me, you would probably want a set of band clamps, you can buy some official ones from wasp slingshots but if you want to print some here it is,
print both the washer and the clamp twice for each fork, if you shoot TTF just rotate the clamp, I suggest using some super glue to glue the M5 Nut onto the clamp piece, M5x20 bolts are used, don't over tighten too much as it will break your frame
Print Settings
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
40
Filament: eSun PLA+ Gray
Notes:
print washer side down, with supports to leave the surface with the notch smooth
If you are getting uneven clamping, feel free to use a knife and skim off the two strips of plastic to shape it a bit better
Category: Sport & Outdoors