20mm desk Clip 20mm section
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small cable clip designed for desks no thicker than 20mm one of several and designed to interlock with other clips.
- Ocena
- 4 / 5
- Polubienia
- 3
- Pobrania
- 31
- Wydruki
- 1
- Wyświetlenia
- 246
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
This is a desk cable clip designed to hold cables along the desk helping with cable management.
I have made several clips in different sizes and are designed to fit onto desks that are up to 20mm thick of course thinner desks will require a resize or use of spacers to make a firm fit.
I have printed this using Bambu Labs PLA purple at .20 layer height and 15% infill with no supports. The clip is designed to fit together if needed and can be printed no supports though I did need to clean up a loose strand of PLA on the female connector and once done both test pieces fit.
The clips are not designed for any set desk and are generic I have though uploaded the 360 fusion file so anyone is welcome to remix it.
I have created the clip in the following sizes
20mm width
40mm width
60mm width
20mm corner piece
All clips come with a male and female connector