Replacement for Pentair LXLATCH
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My Pentair pool control box latches broke after a decade in the sun.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 308
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
My Pentair pool control box latches broke after a decade in the sun. The part of the latch that broke would require a$50 part to repair.
Not if you have a 3D printer it won't.
I measured the part and created a new one that should fit the bill. Print in ABS, PETG, PC, or other high-temperature rated filament. If your box is outdoors and exposed to the sun, consider using UV resistant plastics. Not recommended for PLA, PLA+, HIPS, or SLA resin printing.
(The photos here are of a beta version of the part, before I finished curving the bottom side. I thought it would be stronger/harder with a corner, but it doesn't make that much of a difference either way. )
You may need to adjust the scale slightly ( 1% ) up or down to match your latch. Print a few layers and test before printing the whole latch.
Print instructions
Category: Outdoor & Garden Summary
My Pentair pool control box latches broke after a decade in the sun. The part of the latch that broke would require a$50 part to repair.
Not if you have a 3D printer it won't.
I measured the part and created a new one that should fit the bill. Print in ABS, PETG, PC, or other high-temperature rated filament. If your box is outdoors and exposed to the sun, consider using UV resistant plastics. Not recommended for PLA, PLA+, HIPS, or SLA resin printing.
(The photos here are of a beta version of the part, before I finished curving the bottom side. I thought it would be stronger/harder with a corner, but it doesn't make that much of a difference either way. )
You may need to adjust the scale slightly ( 1% ) up or down to match your latch. Print a few layers and test before printing the whole latch.
Print Settings
Printer Brand:
LulzBot
Printer:
TAZ 6
</div>Rafts:Doesn't Matter
Supports:
Yes
</div>Resolution:200 micron
Infill:
100%
</div>Notes:
Print at 100% infill, 4 permeters ( 1.6mm ), 200 or 300 micron ( 0.2-0.3mm ) with supports. I used 15% supports in both Cura and S3D with very good results.
PETG / 0.4mm nozzle / e3d AERO
Custom Section
Designed in TinkerCad