1 / 8
Anycubic Kobra Go/Neo/2 Neo Dual Z axis mod
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dual Z axis mod for Anycubic Kobra Go/Neo with timing belt.
- Ocena
- 5 / 5
- Polubienia
- 83
- Pobrania
- 372
- Wydruki
- 2
- Wyświetlenia
- 6725
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 2) (Komentarze: 4)Remiksy (0)Kolekcje (107)Powiązane
Attention! Still WIP but ready to use
Also fit to Kobra 2 Neo
Installation notes:
- Install the shorter old screw on the passive side and the new one to the lead side.
- Replace anti backlash nut with an oldham coupler on lead screw (with the same bolts).
- Replace the outer bolts on passive block with longer ones.
Additional parts needed:
- M5x40 bolt (passive block bracket) - 2pcs
- M5x20+ bolt and nut (tensioner pulley) - 1pcs
- M5x20+ bolt and nut (bearings bracket) - 4pcs
- M3x40 bolt and nut (bearings bracket fix. i use square nuts) - 4pcs
- M4x15 bolt (replace filament spool holder) - 2pcs (M4x20 with filament holder)
- M3x12 bolt (oldham coupler passive block bracket Z-axis) - 2pcs
- Horizontal Brackets T8 Lead Screw (KFL08 ID8mm) - 2pcs
- T8 Lead Screw OD 8mm Pitch 2mm Lead 8mm (365mm) - 1pcs
- GT2 Closed Loop Timing Belt (6mm 610mm) - 1pcs
- GT2 Timing Pulley (20Teeth Bore 8MM) - 2pcs
- GT2 Tensioner Pulley (Bore 5 Width 6 with teeth) - 1pcs
- Oldham Coupler - 2pcs. !!! STRONGLY RECOMMENDED
- Square nuts M3x6x6x2mm - 4pcs (can be replaced with regulars)
- Passive block 1pcs (can be replaced with printed)
Note: All links only for information. These parts were used by me but you can buy the same parts at any local store or online.
ToDo:
- Redesign tentioner
Please don't push me hard, because I'm newbie
Remember to post a "I made one" if you do ;)