Minimalistic Ender 3 Enclosure for Bigtreetech SKR 1.4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A minimalistic electronics enclosure to put the BigtreeTech SKR 1.4 in a box at the front of an Creality Ender 3.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 144
- Wydruki
- 0
- Wyświetlenia
- 1866
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
A minimalistic electronics enclosure to put the BigtreeTech SKR 1.4 in a box at the front of an Creality Ender 3.
Print instructions
Design goals:
- Under 2 hr print.
- No supports.
- Viewable faces flat on the bed for best finish.
- Reuse of screws (M3's did not work out they are too short).
- No extra screws -> the back snaps in the 4040 profile.
- Reuse of standard lid (and fan) so I didn't have to print that.
Print Instructions:
- No support
- 100% infill
- 0.16mm layer height
Rationale
All of the enclosures I could find used to much plastic, supports, different mounting hardware etc.
After upgrading to a BTT SKR 1.4 on my Creality Ender 3, I needed somewhere to put my board. Preferably in the front. Teaching Tech has one for the back.
It is made for the Ender 3 and the BTT SKR 1.4. But if sufficient interest, I could adapt this to other boards/printers.