1 / 1
3DXTECH Spool Ring for Bambu AMS
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The filament spools from 3DXTECH cannot be used with the stock Bambu AMS. After upgrading the AMS with hydra 1.07, two issues remain - the edge of the spool is not 90 degrees; therefore the spools slip on the drive roller and second, there are four indentations along the perimeter. This spool ring address both problems.
Note, the rings are popped on from the filament side, not the outside. I printed the rings in ABS. Rings are tight and require a few tries to snap on, but they stay on and do not slip.
Use this link for the hydra update https://www.printables.com/model/392134-hydra-ams-enhanced-bambu-lab-ams