Square utility/spice jar with sliding lid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple 45x45x50 box with sliding lid
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 150
- Wydruki
- 0
- Wyświetlenia
- 569
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple model I did to fit a 5x3 grid of them in my spices box.
It has a sliding lid for the ease of opening it.
Can be used with no problem for storing screws, bolts etc.
I personally printed it with PLA, because I believe it to be safe enough for storing dry spices, but if you're more concerned about food safety than I am, then print it with a stainless steel nozzle using a transparent PETG or make sure that the filament dye is not toxic.
Print with 0.4 Nozzle (I managed it also with a 0.6, but it tended to leave some imperfections inside the rounded corners on the top of the print, where the lid snuggles into the jar, so you're better off using a smaller diameter), layer height of 0.2 mm or less for best results.