Remote control protection box for "Verisure"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
protection box for "Verisure " home alarm activation / deactivation remote control
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 140
- Wydruki
- 0
- Wyświetlenia
- 905
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Which “Verisure” alarm remote control user has not made a mistake with their remote control? the original box having buttons that are too flush with the box, it often happens that when storing the remote control in a bag, for example, a button is pressed by mistake. The status of the alarm can then be changed with all the inconveniences that this may entail.
I have made a small protective box that overcomes this problem.
To do this, I made two small pieces of PETG and used a point cut to the right length to make the hinge. Depending on your availability of points, it may be necessary to readjust the drilling of the parts.
I print the pieces upright with an angle of about 45- 50 degrees. I noticed that it was this position that left the cleanest possible impression. I have voluntarily limited the supports to the maximum.
After a small finish with water sandpaper, the case looks good and you can use your remote control without any worries.