Homebrew Wifi/GPS Celestron enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case for a Wifi + GPS + ESP32 project used to connect to Celestron telescope mounts.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 752
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
An updated, more compact version is available here:
https://www.prusaprinters.org/prints/67382-homebrew-wifibluetooth-gps-accessory-for-aux-bus-c
Original:
This is a case for a Wifi + GPS + ESP32 project used to connect to Celestron telescope mounts. The project can be found here:
https://www.cloudynights.com/topic/743750-homebrew-wifibluetooth-accessory-for-aux-bus/ . Post 220 shows it wired up.
This was spawned from an earlier project that just used an Arduino to provide GPS data to the mount. The new project adds Wifi capability to mimic the dongle.
This particular design is suitable for a 1/2 length protoboard (Adafruit-style) that has central mounting holes, although it could be fairly easily modified for boards that have corner holes, I think. M3x8mm flat head screws were used to secure the protoboard.
The case is held together with M3x 20 or 25mm screws and nuts (25mm will sit a little proud in the sloped section). The exterior screws can be flat/button/socket style.
Print instructions
Print with the large flat faces down. Most printers should be able to handle the 45 degree slope on the front cover. No supports. You might need to clean out the screw holes a bit, again, depending on how well you have tuned things like overhangs and bridging.