HYPR Hot Swap Afterburner

Hot swap afterburner for the HYPR, in similar fashion to my WSPR hot swap afterburner

Wiring diagram is similar to a stryfe. Can also use a stryfe motor braking wiring diagram to make reloading faster.
Micro switch is just glued on the side like the photo.
Battery is just held in by rubber bands.
The flywheel set up in the picture is 2 CC wheels and 2 OOD valkyries.

Hardware-
2 motors
2 flywheels. Cage is a 43.5 dominator base. Use lower crush wheels so you can stick darts through the flywheels.
2 10-32 caliburn screws
3 10-32 nuts
lever micro switch
4.2 inch .527 caliburn barrel for the main barrel and a 1.2 inch 5/8 od barrel for the flywheel holder.
18g or lower silicone wire.
6-32 screw for battery mount
heat shrink
whatever battery to go with the motors and connectors for it.
superglue
loctite of some kind
flywheel cage screws x4
some rubber bands
optional- 10-32 thumbscrews for hot swap feature.

Crediting Ofp here because thingiverse doesn't have a remix on here.
Remix of https://www.thingiverse.com/thing:4313968
https://www.thingiverse.com/thing:4531968 since thingiverse is bork af and won't let me list them as remixes

Print instructions

Print Settings

Printer Brand:

Prusa

Printer:

No

Supports:

.1-.2

Infill:

Notes:

Support on build plate for flywheel cage.

Brim on battery mount