USB Desk Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for placing USB-A extension cables under the lip of a desk
- Ocena
- 4,5 / 5
- Polubienia
- 18
- Pobrania
- 116
- Wydruki
- 2
- Wyświetlenia
- 614
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
After replacing my monitor with a new one that didn't have USB outlets on the side, I spent a lot of time reaching under the desk to plug/unplug/replug stuff.
I designed this mount in an evening to hold the ends of a couple USB3 USB-A - to - A cables, as though the desk had built-in USB outlets.
I used Amazon USB3 Cables (ASIN: B014RWAMWC ) - there's no guarantee others will work, but you can look at this design for inspiration.
I never printed the single-cable mount, just the two-up, though the two-up was made from a couple copies of the single one, and the single one should work the same.
The mount uses a slight well to let the cable's fat logo badge sink in, and a little 1mm hump in front of the Type A jack, to prevent the cable end from working out. It could be bettered by rounding the corners a bit.
Be careful not to bust off USB drives plugged into your desk!
I printed with PLA, a raft, 40% infill. Printed with open-side down, so rough edges wouldn't be apparent to casual observers.