Original Prusa Enclosure Top Plug PTFE M6 x3 Pass Through (Mosaic Palette 2 Support)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A top plug for the original Prusa enclosure with 3 PTFE tube fitting connections (w/ optional support for the Palette 2)
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 79
- Wydruki
- 1
- Wyświetlenia
- 731
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
I was looking for a top plug that I could use to guide my spools that I'm drying (with my Sunly Filament Dry-Box: https://www.printables.com/model/85989-sunlu-dryer-ptfe-adapter) nicely into the printer enclosure, and this for the M6x4 pneumatic PTFE connector: https://www.123-3d.nl/123-3D-Pneufit-rechte-koppeling-M6x4mm-i1623-t15192.html
But I'm also printing multi color with the Mosaic Palette 2 Pro, so if possible I wanted to be able to attach that (with it's grommet and thicker PTFE tube) to this top plug as well.
So it comes in 2 versions:
- One with 3 PTFE pneumatic fittings connectors
- One with 2 PTFE pneumatic fittings connectors and in the center the built-in Mosaic Palette 2 (Pro) grommet PTFE guide.
Printing
The 3MF files are included. However when slicing yourself you should pay attention that you have some supports in place on the bottom of the plug. This support will come of easily with a scraper after printing. That's all supports that is needed (same for the one that supports the Palette 2).

I've printed this in PETG and 0.3mm layer height with an infill of 15%.
Installation
- Use the plastic rivets to secure it to the top of the enclosure.
- On the top you can secure 2 or 3 pneumatic PTFE fittings with an M6 thread (I used a wrench size 10 (EU) to gentle get them all screwed it)
- Inside the enclosure when loading your filament you should be able to snug your PTFE tube inside the plug so your filaments guides nicely through. It's been designed for PTFE tubes with an outside diameter of 4mm to snug in easily!
- Then you can use that PTFE tube to guide it right to your extruder. All nice and clean!

