EEW Nano Motor Pulley
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 3D-printable motor pulley to replace the stock one on a Dreaming Robots Electric Eel Wheel Nano. It'll work…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 344
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a 3D-printable motor pulley to replace the stock one on a Dreaming Robots Electric Eel Wheel Nano. It'll work with either the v1.0 or v1.1 motor, and you may need a drop of CA glue to secure it to the motor shaft.
This is the pulley that I sell on my website.
Print Settings
Printer Brand:
LulzBot
Printer:
TAZ 4
Rafts:
No
Supports:
Yes
Resolution:
0.1mm
Infill:
35%
Filament:
Any PLA
Notes:
I have my supports as follows (S3D settings, but can be adapted to other slicers):
Support Infill Percentage: 20Extra Inflation Distance: 1.6mm
Support Base Layers: 1 (doesn't matter)
Combine Support Every: 2 layers
Max Overhang Angle: 55°
Horizontal Offset: 0.55mm
Upper Vertical Separation Layers: 1 (or 0.1mm)
Lower Vertical Separation Layers: 2 (or 0.2mm)
Dense Support Layers: 5
Dense Infill Percentage: 90
Support Infill Angles: 0
Post-Printing
Afte printing, remove supports with pliers. You should be able to grab the supports sticking out the side and pull them out. Go around the pulley with a sharp tool to scrape out any remnants inside the groove.
Category: Parts