1 / 5
Starlink WiFi Router Wall Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount for 2nd Gen Starlink Wi-Fi router
- Ocena
- 5 / 5
- Polubienia
- 154
- Pobrania
- 1854
- Wydruki
- 6
- Wyświetlenia
- 6303
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 6) (Komentarze: 8)Remiksy (1)Kolekcje (224)Powiązane
This wall mount is designed for the Wi-Fi router for the 2nd Gen Starlink kit. Cables can leave the back or the bottom. Designed so the back of the router is vertical. The four holes in the backplate are M5 sized. Optimized as much as possible for 3D printing, only a minor bit of support is needed at the back.
The model in the photo's is printed in PLA Pro.
Recommended print settings for a sturdy mount:
- Layer height: 0.1 mm - 0.3 mm (Depending on time requirements and desired finish)
- Wall loops: 4
- Infill type and density: Cubic 20%
- Support: On - Normal
Update May 16th 2024
V2 model - changes:
- Further optimized model for 3D- printing, with special regards to the cable entry from the back.
- Holes in the backplate changed to teardrops for best quality and strength
- Higher .STL quality and fixed default orientation
- Slightly increased mechanical strength by adding bigger chamfers near the back, connecting with the bottom.
- Rounded the printbed-contact-surface so it has better first layer adhesion, decreasing the need to use a brim.
- Some slight adjustment to design of the top, which looks better with the vertical print orientation.
- Added G-Code for Bambu P1S (To be found in the model section due to the .3MF file) [PLA - 0.4mm - Textured Plate]
For feedback, ideas and/or other notes, please post a comment.