1 / 5
1/4" loc-line flexible LED light - 2040 NPT mount — zdjęcie 1
1 / 5

1/4" loc-line flexible LED light - 2040 NPT mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

40mm wide 1/4" NPT mount and a 1/4" loc-line lamp, meant for two 100mm strips of 10mm wide LED strip lighting. Using…

Ocena
0 / 5
Polubienia
13
Pobrania
81
Wydruki
0
Wyświetlenia
750
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

40mm wide 1/4" NPT mount and a 1/4" loc-line lamp, meant for two 100mm strips of 10mm wide LED strip lighting. Using two pieces of loc line and a 1/4" NPT adapter (like $8 for the loc line kit).

M3 screws for the NPT mount.

The strip holder doesn't have a hole in it, because I printed it standing on it's end (loc-line up) and it can't bridge if there's a hole in the middle. I just drilled it out afterwards to pass the wiring through.

It'll be a jerk to assemble if you print it out of PLA (PETG recommended), but it is possible. Easier with the correct loc-line pliers. The alternative is to print it a tiny bit oversized (or soften it with a heat gun) and put a little CA glue in the cup. Won't stick to the loc-line, but it will tighten the fitting back up once you get it on.

Print Settings

Printer:

SecKit Sk-Go

Supports:

No

Resolution:

.2

Infill:

20

Filament: 3D Solutech PETG/PLA Black


Notes:

Shouldn't need support, if the lamp is printed on it's end (loc-line up), it's an easy bridge at the top. Brim would be wise.

NPT mount prints great sitting normally, threads fit great.

Category: Electronics

Tagi