Sovol SV06 Screen Case (SV-GBox)

SV-GBox 

This screen mount was designed to solve a few small issues with the original.

Features

1. Rotates the screen further forward for better readability. 
2. Adds USB access to the front of the printer. The link to the passthrough this was designed for can be found at the bottom of this description. Once you've installed the usb passthrough you can use a standard cellphone cable that is micro usb on one side and regular usb type a on the other to connect the passthrough to the motherboard case in the rear.
3. Adds convenient drawer to the front of the printer
4. Adds storage to the rear of the screen
5. Brings the base of the screen mount  down to your table or work surface so that the mount doesn't shake or break over time.
6. Adds cable slot below the mounting holes to allow screen and usb cables to pass under the printer where the cable clamps are.
7. Comes with three drawer options and three rear options with or without storage.

Printing Opinions

Main Body: The main screen body may print best with the drawer / usb face, facing down to the bed. Or the screen face down to the bed. Either way some supports may be required. 

Drawers: The front sliding drawers can printed as is with the bottom of the print on the bed

Knob: Should print fine upside-down (with the top of the knob touching the bed)

Rear Storage: Print standing as in the images with small supports on the overhanging slot stops

Drawer Stop: Print on its side as is (Should be like that in the file already)

Remember to share your makes!

USB Passthrough: https://www.amazon.com/PENGLIN-Connector-Bulkhead-Extension-Interface/dp/B09WM8737J/ref=asc_df_B09WM8737J/?tag=hyprod-20&linkCode=df0&hvadid=658824461252&hvpos=&hvnetw=g&hvrand=16448772592827293954&hvpone=&hvptwo=&hvqmt=&hvdev=c&hvdvcmdl=&hvlocint=&hvlocphy=9060248&hvtargid=pla-1964907029742&psc=1&gclid=CjwKCAjw8ZKmBhArEiwAspcJ7p7APfHZWEgNGm80VJBJ93oMIjBijtFQqa3R7IKdFCHmG9XuWebu7xoCJVAQAvD_BwE