OneTuff Honeycomb spool frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use to hold all them filament rolls that seem to build up over time!
- Ocena
- 5 / 5
- Polubienia
- 110
- Pobrania
- 370
- Wydruki
- 9
- Wyświetlenia
- 2036
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
19/12/23: Uploaded center/passthrough frame with a new modified model to support a screw fixing on the top hex.
15/12/23: Updated with a new modified model to support a screw fixing on the top hex.
After looking at my spool holder with full spools on it….The hexwall was coming away from the wall!!
I will reprint mine with PETG and try this screw fixture frame mod. 6 perimeters.
Updated with a passthrough model.
Angle brace is now stronger.
In your slicer, right click on model and select mirror Along X-Axis. Now you have the frame.
Print any resolution. All my test prints were .28 15% infill. I've had frames snap on me (while taking it back off the honeycomb wall…Too good i think :) so maybe more infill… I will be updating it in the future.
The drop in holes are 28mm (standard broomstick pole here). The aliexpress 8mm carbon fibre rods work extremely well. Ill make an adaptor for these rods just to snug in nicer.
Also will upload a passthrough frame soon.