Print Your Own Gradient Filament
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Inspired by Turbo_SunShine's design, I wanted to go further.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 730
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution
Inspired by Turbo_SunShine's design, I wanted to go further. I've marked this as a "remix", but the openscad and stl files are original -- just the idea is inspired by TSS
This experiment shows that if you have a multi-material printer, you can use TSS's technique to create a gradient filament. Here, I demonstrate a small 2-material filament section created via openscad. It produces only about ~2g of filament, less than 1 meter.
The OpenSCAD program that produces the files is a piece of junk and takes quite a bit of time to run. As such, it is not feasible to make it into a customizer at this time. (also, I think the scad file doesn't match the stl files provided, oops!)
The frog model is here and the vase model is here
Print instructions
Resolution: 0.2mm
Infill: 100%
My sample is made of some "bronze filament" and some glow in the dark PLA. However, you should be creative and try whatever sounds fun.