Watch Movement Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Another tool for my watch-repairing friend at http://timeguy.com this parametric OpenSCAD model can be used to create…
- Ocena
- 4 / 5
- Polubienia
- 47
- Pobrania
- 261
- Wydruki
- 2
- Wyświetlenia
- 3204
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Share Alike
Another tool for my watch-repairing friend at http://timeguy.com this parametric OpenSCAD model can be used to create watch movement holders. Included are tested models for 12s, 16s, 17s and 18s movements. All models worked after a small amount of finishing (sanding). The notches seen in the photo are also made post-printing.
An untested holder for an Accutron 214 is now included, after a request in the comments. It's based on measurements: 28.9, 26.1, 24.5, 27.8 and heights 2, 4, 9, 13. Timeguy doesn't need one and I don't have any 214s to test it with.
Note the fudge factor function F(x). I found that I had to oversize inside diameters by 0.25mm on my printer. If your needs are different, you can regenerate the models with different F(x) offsets, or use slicer functionality similar to cura's "horizontal expansion".
Print instructions
Prints fine at 0.2mm without supports. I used PLA.