Rain Barrel Vent
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple no supports vent for a rain barrel, bucket, tote, etc.
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 104
- Wydruki
- 2
- Wyświetlenia
- 601
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a simple vent I designed for a water storage barrel to keep it vented and prevent it from creating negative pressure inside when a pump is ran.
It is in 3 pieces, and shouldn't need any supports (if printed in the imported orientation,) but you can use them on the cap if you'd like. You may want to use a brim on the main body, but I didn't need too.
There are small slots on the underside of the cap to help prevent bugs and debris from getting in. To install, drill a 1"/25mm hole in the lid of your drum lid/bucket lid/IBC tote, and the rest will thread together. I would recommend using PETG, ASA, or ABS if the container will be outside in the sun and weather. The threads went together on my well tuned printer, but you may need to clean them up slightly if you're printed isn't calibrated.
Note: The printed one in my pictures is a slightly older revision, I have tweaked it for the better.