12g shotgun reloading insert (Snap cap)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed for Federal Top Gun 2 3/4" shells (cheap!) Used in place of the internals (primer, powder, wad, etc.)
- Ocena
- 4 / 5
- Polubienia
- 21
- Pobrania
- 151
- Wydruki
- 2
- Wyświetlenia
- 1068
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
This was made so I could reuse cheap shotgun shells to make 12 gauge shotgun snap caps. I found some 3D models but nothing that fit. It was designed using Federal Top Gun 2 ¾" shells
I printed in ABS and PETG, both with 35% fill and 4 walls.
I use a Lee Load-All reloading press to prep/deprime the shells. Load this insert on the middle (wad) station and make sure it is fully seated before proceeding to crimp as normal.
A friend of mine even added a drop of silicone to the primer pocket to make it more flush and give a buffer between the firing pin and plastic.
These can be used for function checks, dry fire and to simulate jams. They should cycle exactly like their retail counterpart.
*I only have high brass on hand for comparison.