6inch Fishing Worm Mold - Hand Injected
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Mold for a 6-inch Rubber Worm Fishing Bait. Texas Rigged preferably and any standard Hand Injector can be used
- Ocena
- 0 / 5
- Polubienia
- 35
- Pobrania
- 227
- Wydruki
- 0
- Wyświetlenia
- 1099
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
This 3D Printable Worm Mold is for a Big Boi 6 Inch Plastic Worm. Throw an O-ring on it and Huge Largemouth Bass will find it irresistible. I'm currently in the middle of testing durable Biodegradable Options over Plastisol but for the time being, I recommend Plasticsol due to the weight when casting.
For this Mold platform use the following Sized Screws and Heatsets. A Standard Plastic Hand Injector will work fine for this mold.
- 6x M3 * 25mm
- 6x M3 Generic Heat Insets
Enjoy!
NOTE: Edited to add better layer lines for M3 Screw Holes. Easier printability. Also added Cura Profiles with Presliced Models. M3 Screw Holes were to be used rather than M2, Whoops. The model is printing today, So I'll check the results.
8/9/2023 - After testing I found that the bait is simply too thick to float freely on a standard O-Ring within the water. Also, a cavity formed at that top inlet when using the hand injector. Decided to thin the model a bit and move it down to allow for a chamber to reduce the cavity at the top. I will have to test it again.